Mesure et protection
Measuring transducer and protection device for single- and three-phase power systems.
-
- connect a PLC via CAN bus
- use relays to push commands and to control a breaker
Measurement
| easYprotec 1410 | MFR300 | |
|---|---|---|
| Les fonctions | ||
| PCM1-M-15B/H | ||
| PCM1-M-41B/H | ||
| PCM1-M-I5-U4-H | ||
| PCM1-M-11B/HA | ||
| Configurable delay timers for PCM1-M-I1-U4-HA | ||
| 4 configurable relays (change-over) | 2 | 4 |
| 1 “Ready for operation” relay | ||
| Switchable relay logic | ||
| 2 kWh counters (max. 1012 kWh) | ||
| 2 kvarh counters (max. 1012 kvarh) | ||
| CANopen / Modbus communication | ||
| Configurable via CAN bus / RS-485 / Service Port (USB/RS-232) | ||
| Configurable via Service Port (USB / RS-232) | ||
| protection | ||
| Over-/undervoltage (59/27) | ||
| Over-/underfrequency (81O/U) | ||
| Voltage asymmetry (47) | ||
| Overload (32) | ||
| Positive/negative load (32R/F) | ||
| Unbalanced load (46) | ||
| Phase shift (78) | ||
| Overcurrent (50/51) | ||
| df/dt (ROCOF) | ||
| Ground fault | ||
| QV monitoring | ||
| Voltage increase | ||
| Freely configurable time-dependent undervoltage monitoring for: FRT (fault ride-through) |
MFR-300 Multifunction Relay / Measuring Transducer with CANopen / Modbus Communication
The MFR 300 is a measuring transducer for monitoring single- and three-phase power systems. The MFR 300 has both voltage and current inputs for measuring an electrical power source. A digital processor makes it possible to accurately to measure true RMS values, regardless of harmonics, transients or disturbing pulses. The primary measured and calculated values are transmitted via CANopen / Modbus protocol to a supervisory control system.
The MFR 300 performs monitoring functions for mains decoupling, including four freely configurable time-dependent undervoltage monitoring functions for FRT (fault ride-through).
The primary measured values of voltage and current are used to calculate the real, reactive, and apparent power and the power factor (cosphi) values.
Accessoires
Boîte à outils
configuration via Woodward’s standard Software Toolkit.
Interface de configuration USB
Interface de configuration des ports USB. Le côté PC/ordinateur portable est séparé du côté de l'unité Woodward par une isolation galvanique.
numéro de pièce : 5417-1251